![]() ![]() The alfa does not show up anywhere, and I can't seem to find a reasonable solution.Įdit 1: after installing Kali 2021 on a notebook and doing the same procedure, the result is the same. Hubīus 001 Device 001: ID 1d6b:0002 Linux Foundation 2.0 root sudo airmon-ng TX errors 0 dropped 0 overruns 0 carrier 0 collisions lsusbīus 002 Device 001: ID 1d6b:0003 Linux Foundation 3.0 root hubīus 001 Device 002: ID 2109:3431 VIA Labs, Inc. TX errors 0 dropped 0 overruns 0 carrier 0 collisions 0 Tx excessive retries:0 Invalid misc:0 Missed beacon:0Įther dc:a6:32:a6:7a:34 txqueuelen 1000 (Ethernet) Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0 Retry short limit:7 RTS thr:off Fragment thr:off The alfa antenna was connected to an USB3 port prior to booting the pi. I'm running kali on a headless pi over ssh. ![]() I have also connected the raspberry to my local WiFi before inserting the alfa into the raspberry, so I do have an internet connection via the pi's internal network card. Though it looks like it is not on my system, because the antenna is not detected by the system in any way. I have read that the antenna is supported out-of-the-box by kali, and that it should be detected without further action. So I am assuming the system is powered up correctly. When plugging the Alfa USB cable in the booted pi (I tried all the USB 2 and USB 3 ports), the Alfa signal LED lights up and stays lit. Kali Linux RaspberryPi 2 (v1.2), 3, 4 and 400 (64-Bit)), which is installed on the Raspberry pi 4 model B. I'm trying to configure and get up running the Alfa AWUS036NH on my Kali linux system ( Image here. ![]() I'm having an issue with my raspberry detecting the Alfa antenna I got. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |